AddPac VoiceFinder AP2120 User's Guide download pdf (Page 108)

VoiceFinder AP2120 VoIP Gateway User’s Guide Version 1.00

AddPac Technology Co., Ltd. -

108 -

configuration location.

2. NAT-list-number : Define any number between 0 and 7.

3. Start-address/End Address/Mask : Define the start address and the end

address of NAT and the subnet masks for these addresses.

z nat <nat-list-number> nat inside-global <start-address> <end-address>

<local-ip address >

1. Creates a NAT pool for the outside global address in the global

configuration location.

2. NAT-list-number: Define any number between 0 and 7.

3. Start-address/End Address: Designate the start address and the end

address to use in the NAT.

4. Local –IP-Address: When there is a subnet that uses a registered IP in the

local network, the user can register this subnet in the outside interface

to route and advertise the subnet to the outside network.

z nat <nat-list-number> nat static-entry <inside-local-address>

<outside-global-address>

1. When it is necessary to access servers in the local network from outside,

the user can define static entry for address translation with this

command.

2. NAT-list-number: Define any number between 0 and 7.

3. Start-address/End Address: Define the start address and the end address

that NAT uses.

z nat <nat-list-number> nat time-out <timer-value>

1. Defines time value for the NAT list to recover the address into free status

when communication is idle.

2. The default is 300 seconds.

z nat-group <nat-list-number> {nat/pat}

An interface command. Applies the NAT-list that has been set in the global

mode to the corresponding interface.

nat <nat-list-number> pat < pat-address >

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 354 355

No comments

AddPac VoiceFinder AP2120 User's Guide Page 108