AddPac VoiceFinder AP 160 User's Guide download pdf (Page 39)

VoiceFinder AP200 VoIP Residential Gateway (RGW) User’s Guide Version 1.1

AddPac Technology Co.,Ltd. -

39 -

Chapter 4. Gateway Configuration and Commands

This chapter describers how to configure the VoiceFinder AP160 dial-up VoIP

gateway and commands of the VoiceFinder AP160 dial-up VoIP gateway.

In this part, we only explain the AP160 specific configuration and commands.

Please refer the AP200 user’s guide about the other part or common part of

VoiceFinder series.

4.1. Gateway Booting

The operator can use all commands of the AP160 through the consol or telnet

connection.

When power is supplied, the gateway is booted as follows:

z The gateway performs a self-test and checks basic operations of the CPU,

the memory and interfaces.

z The boot loader is executed, and the boot loader seeks for proper

gateway software image files. In the default configuration, the boot

loader loads gateway software in the flash memory.

z If the boot loader does not find any proper gateway software image file

from the flash memory, the boot loader stands by in the boot mode until it

receives proper gateway software from the system. (At this time, the

boot loader can download gateway software through TFTP or FTP

protocol.)

z When gateway software is loaded, gateway starts to operate according to

configuration information saved in the gateway. However, if there is no

configuration information, the gateway operates according to the default

values, and in this case, the operator shall set up related items for normal

operation of the network.

Information

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 67 68

No comments

AddPac VoiceFinder AP 160 User's Guide Page 39